bought a mini table saw

put the blade in, spins down towards the wood on the table saw...the wood is on top of the machine, and has that counter pressure.

put my 12volt 2.1mm solar output cable in, it started to make a cut in wood scrap about 2 cm before i decided to put more power in, and have decided to buy a new blade....

the side guide works nicely, you must use a wood push stick. learnt from the internet :)

anyway good thing! one day i'll use it to make more laser engraved alphabet letters and more.

ok so i try again, with the solar output 12volts ... turn it round the wrong way and try to make a graded sloped cut- machine seems to jump around...

turn it back round to make smooth purr from the machine cuts like tiny axes, so that time was good :) washer the blade shipped with seemed to fit it that way round.

do some quick cuts from the solar charge controller (be patient with each cut)

sand paper and nail a box one day